水泥檢查井模具的砂輪主軸作一次橫向進給，待工件表面上層金屬磨去后，砂輪再按預(yù)選磨削深度作一次垂直進給，以后按上述過程逐層磨削，直至切除全部磨削余量。水泥檢查井模具橫向磨削法是常用的磨削方法，適于磨削長而寬的平面，也適于相同小件按序排列，作集合磨削。

The main shaft of the grinding wheel of the cement inspection well mold shall be transversely fed once. After the first layer of metal on the workpiece surface is ground off, the grinding wheel shall be vertically fed once according to the pre selected grinding depth, and then ground layer by layer according to the above process until it is cut off

Full grinding allowance. The transverse grinding method of cement inspection well mold is the most commonly used grinding method, which is suitable for grinding long and wide planes, as well as the same small parts arranged in order for collective grinding.